History

V3 Review

  • "http://ohwr.org/projects/fmc-tdc" on bottom overlay should be "http://www.ohwr.org/projects/fmc-adc-100m14b4cha".
  • Replace R8 etc. (825R/0805) by 825R/0603.
  • Replace R30 (2k2/0603) by 2k2/0805.
  • Replace R132 (10k/0603) by 4k7/0603.
  • Replace R90 (510R/0603) by 511R/0603.
  • Replace R93, R130 (330R/0603) by 511R/0603.
  • Replace R102 (13k/0603) and R103 (86k6/0603) by 75k/0603.
  • Replace R104 (150k/0603) by 130k/0603.
  • Replace R105 (68k/0603) by 330k/0603.
  • Replace R84 (510R/0603) by 243R/0603.
  • Replace R87 (1k8/0603) by 825R/0603.
  • Replace R88 (150R/0805) by 120R/0603.
  • Replace R89 (47R/0603) by 86R6/0603.
  • Remove R136 (47R/0603) on the 1-wire interface.
  • FMC front panel is delivered with Philips screws, but the assembly BOM specifies 8x slotted screws Bossard ref: 1123238.
    => 8x slotted screws Bossard ref: 1243896 must be used (see FMC components).
  • Connect Si570 Vc pin to the FMC connector via a RC filter (1-bit DAC from FPGA for WR applications) ????
    => If needed, this feature will be added to the next revision of the board.

EDA-02063-V3-0_sch.pdf - schematics V3 for review (3.4 MB) Matthieu Cattin, 28/06/2011 08:18

EDA-02063-V3_mfg.pdf - layout V3 for review (230.9 kB) Matthieu Cattin, 28/06/2011 08:19

EDA-02063-V3-0_pcb-mat.pdf - BOM V3 for review (30.6 kB) Matthieu Cattin, 28/06/2011 08:19

EDA-02063-V3-0_arrangement.pdf - arrangement V3 for review (143 kB) Matthieu Cattin, 28/06/2011 09:00

EDA-02063-V3-0_arrangement-mat.pdf - arrangement BOM V3 for review (16.2 kB) Matthieu Cattin, 28/06/2011 09:00