Projects

Filters

  • Beam Positoning Monitor - RF Front-End
    Signal conditioning electronics for BPM pick-ups providing 4-channel RF signal analog filtering, amplification, digitally controlled attenuation and several calibration schemes....
  • CERN ELMB
    ELMB is an analog/digital input/output module with CANbus interface. About 10000 of ELMBs are used in various CERN installations of...
  • nanoFIPDiag
    nanoFIPDiag is a WorldFIP module dedicated to monitoring and diagnostics. It uses a NanoFIP chip in order to be Radiation Tolerant....
  • AMC FMC Carrier (AFC)
    AMC FMC Carrier.More info at the Wiki page...
  • CROME
    The CROME board (Cern RadiatiOn Monitoring Electronics) is the new read-out electronics for radiation protection at CERN. It performs analog-to-digital conversion of the current signal generated by the radiation detectors (ionization chambers) installed in and outside CERN perimeter providing a continuous real-time measurement of ambient dose equivalent rates. It generates radiation alarms, interlock signals and provides long term permanent and reliable data logging....
  • FMC ADC 100M 14b 4cha
    FmcAdc100M14b4cha is a 4 channel 100MSPS 14 bit ADC low pin count FPGA Mezzanine Card (VITA 57). Input ranges: +/-50mV, +/-0.5V, +/-5V. The offset correction by +/- 5V is possible for each gain range. Commercially available....
  • FMC ADC 10M 16b 2ch DAC 50M 16b 2ch
    The Peak Position Detector is a 2 differential channel 10MSPS 16 bit ADC (AD7626) card in FMC (FPGA Mezzanine Card) format. It uses an LPC VITA57 connector. The gain can be set by hardware (default = 41). Two general purpose 50MSPS 16-Bit DAC are implemented and can be programmed as a voltage source....
  • FMC ADC 125M 14b 1ch DAC 600M 14b 1ch
    An FMC board with an analog 125 MS/s input and an analog 600 MS/s output for RF applications....
  • FMC ADC 130M 16b 4cha
    4-channel 16-bit 130 MS/s (700 MHz analog input bandwidth) ADC (LTC2208) FMC module....
  • FMC ADC 1G 10b 2cha
    The FmcAdc1G12b2cha is a 2 channel 1GSPS 10 bit ADC card in FMC (FPGA Mezzanine Card) format using an LPC connector. The gain can be set by software in three steps: +/-50mV, +/-0.5V, +/-5V. An offset circuit is used in the front-end design of the ADC board and allows a voltage shift in the same range as the chosen gain....
  • FMC ADC 200k 16b 11cha
    FmcAdc200k16b11cha is an 11 channel 200kSPS 16 bit ADC card in FMC (FPGA Mezzanine Card) standard. The input voltage range is settable to +/-10V or +/-5V. The input impedance is 1MOhm....
  • FMC ADC 250M 12b 2cha
    The FmcAdc250M12b2cha is a 2 channel 250MSPS 12 bit ADC card in FMC (FPGA Mezzanine Card) format using an LPC connector. The gain can be set by software in three steps: +/-50mV, +/-0.5V, +/-5V. An advanced offset circuit is used in the front-end design of the ADC board, and allows a voltage shift in the range of +/- 5V that is independent on the chosen gain range....
  • FMC ADC 2M 18b 2ch DAC 500k 20b 1ch
    The B-Train integrator is a 2 differential channel 2MSPS 18 bit ADC card in FMC (FPGA Mezzanine Card) format. It uses an LPC VITA57 connector. The gain can be set by hardware (default = 1). A gain & offset self-calibrating function is also implemented. This function uses a 1ppm 20-Bit DAC (AD5791) as a reference and can be programmed as a differential voltage source. The card also includes 8 input/output LVDS pairs and a 10-bit port digital IO where each single-bit port can be configured individually as input or output. The I/Os that are on micro-HDMI connectors are TTL or LVDS compatible....
  • FMC Carrier tester
    An FMC to test the correct mounting of FMC connectors on FMC carrier boards....
  • FMC DAC 130M 12b 4ch 4SFP
    FMC with 4 SFPs, 4 DACs, and 4 TLK2501 chips. The board receives data streams from remote ADCs using an optical serial interface and produces analog outputs for monitoring purposes....
  • FMC DAC 600M 12b 1cha DDS
    An FMC for Direct Digital Synthesis (DDS) applications. It contains a DAC, a phase detector and a PLL chip....
  • FMC DEL 1ns 4cha
    A fine delay generator in FMC format with 1 input and 4 outputs. The resolution is 1 ns. Commercially available....
  • FMC DIO 16ch TTL a
    FmcDIO16chTTLa is a 2x 8-bit port digital IO card in FMC form-factor. Each 8-bit port can be configured individually as input or output. IOs are TTL compatible. Additional test features can be mounted on the PCB....
  • FMC DIO 32ch TTL a
    FmcDIO32chTTLa is a 32-bit port digital IO card in FMC form-factor. ...
  • FMC DIO 5ch TTL a
    FmcDIO5chTTLa is a 5-bit port digital IO card in FMC form-factor. Each single-bit port can be configured individually as input or output. The I/Os that are on LEMO 00 connectors are TTL compatible....
  • FMC HV SUP
    FMC High Voltage supply capable of delivering positive or negative voltage (selectable by components assembly) with voltage and current monitoring. Features FMC LPC, 0...+/- 6kV, up to 4W, Selectable range (+/- 750V, +/- 1.5kV, +/- 3kV, +/- 4.5kV, +/- 6kV), Voltage and current measurement with hardware over-current protection, SHV output....
  • FMC POF 10M R3ch T1ch
    Triple 10MBd POF/HCS optical receiver with single optical transmitter (10Mbd) using an LPC connector....
  • FMC POF 10M R4ch
    Quad 10MBd POF/HCS optical receiver (10Mbd) FMC card using an LPC connector....
  • FMC PowerPC carrier (SPEC-based)
    FMC carrier equipped with a Power PC embedded processor. In addition to the SPEC it has 2 gigabit Ethernet ports, one mini PCIe connector and USB 2.0 HS. It is supplied from a single 12V and runs Linux. The FPGA is configured from the processor and also interfaced using PCI Express x1 and a local bus. The system boots from on-board NAND or NOR flash memory....
  • FMC TDC 1ns 5cha
    An FPGA Mezzanine Card (FMC) with a Time to Digital Converter chip to perform one-shot sub-nanosecond time interval measurements. Commercially available....
  • HiCCE-FMC-128
    We have designed an FPGA Mezzanine card (standard FMC/Vita 57) for high-channel-count electrophysiology, with 128 channels (potentially up to 512), based upon Intan Tech's RHA2132 (2 uV rms input-referred noise), sampled at 25kHz 18bit by AD7982. We are basing our design on the reference design provided by Reid Harrison of Intan Tech for their 16-channel evaluation board. The expected cost of the device should be under 5000$. ...
  • Optical Clock & Data Recovery FMC
    An FMC for clock & data recovery from optical sources....
  • Simple PCIe FMC carrier (SPEC)
    A simple 4-lane PCIe carrier for a low pin count FPGA Mezzanine Card (VITA 57). It has memory and clocking resources and supports the White Rabbit timing and control network. Commercially available. Linux and Labview drivers available for some mezzanine cards....
  • Simple PXIe FMC Carrier (SPEXI)
    A simple 4-lane PXIe carrier for a low pin count FPGA Mezzanine Card (VITA 57). It has memory and clocking resources and supports the White Rabbit timing and control network. Design based on the SPEC. Commercially available. Labview driver available for Fine Delay and TDC mezzanines....
  • Simple VME FMC Carrier (SVEC)
    A simple VME64x carrier for two low pin count FPGA Mezzanine Cards (VITA 57). It has memory and clocking resources and supports the White Rabbit timing and control network. Commercially available....
  • Stand-alone 18-slot FMC carrier
    Stand Alone Carrier with 18 FMC LPC slots based on Spartan FPGAs, mini-ITX board and ATX supply....
  • legacy-vme64x-core
    Legacy-VME64x core implements a legacy VME (VMEbus IEEE-1014) and VME64x (based on the vme64x-core) slave....
  • Conv TTL Blocking
    A level conversion board between TTL and 24V blocking levels in VME64x form factor. The project uses a rear transition module for connectivity and a front module with the active conversion and diagnostics electronics....
  • Conv TTL RS485
    A level conversion board in VME64x double-height form factor between TTL and RS485. Direction and levels are configurable. The project uses a Rear Transition Module for connectivity and a Front module with the active conversion and diagnostics electronics....
  • Neo51
    Neo51 is an open source hardware based on 89V51 microcontroller. It has a dual mode feature selectable via DIP switch supporting...
  • Programmable RF Attenuator in VME
    Programmable attenuator of RF signals with very high voltage range (50 mV – 1000 V) for protecting digitizers against damage by high voltage signals....
  • SFP ADC 130M 12b 1ch DAC 130M 12b 1cha
    Optical 130MS/s ADC/DAC with SFP - for digital transmission of analog signals over fibre....
  • SPICONTROLLER
    SPICONTROLLER is the controller board for the SPI Boards Package. It manage communication task with control system via Ethernet and with modular boards via SPI interface. Moreover, specific process can be embedded into the controller. ...
  • SPIETBOX
    SPIETBOX is a board developed around a SPARTAN-3 FPGA in order to process TTL and SSI encoders....
  • TimEX3
    The TimEX3 is a multipurpose compact PCI board designed to perform simple to medium complex logical functions....
  • Universal C64 Cartridge
    A C64 cartridge with USB connection for uploading CRT files from a PC and for fast turnaround time when developing assembler programs for the C64 on a PC. The board contains a MC9S08 microcontroller, a 128 kByte SRAM and a CPLD, which can be programmed to emulate many cartridge types. With a different firmware it can be used in standalone mode, without a C64, for other applications as well, like a logic analyzer or a motor controller....
  • USB Relay Box 1
    A USB controlled switch box with 1 to 4 switching. Can send out a reference voltage. Multiple configurations possible. Used for the calibration of ADC, TDC and Fine delay mezzanines....
  • VIDEO Processing Platform (MIXXEO)
    Video Processing Platform (MIXXEO). With 2 HDMI inputs, DVI + VGA output, Spartan 6 FPGA, DDR SDRAM memory and Ethernet....
  • VME ADC 250k 16b 36cha
    VME board with 36 ADC channels with a sampling rate of 250 kS/s and 16 bits resolution....
  • White Rabbit
    White Rabbit is a fully deterministic Ethernet-based network for general purpose data transfer and synchronization. It can synchronize over 1000 nodes with sub-ns accuracy over fiber lengths of up to 10 km. Commercially available....
  • AMC CPU COM6
    Double width AMC CPU board for COM EXPRESS mezzanines, dedicated to MTCA 4.0 for physics. It can function either as Standard AMC or RTM in cooperation with dedicated WR-MCH freeing 1 AMC slot....
  • AMC uBackplane SFP
    The AMC micro backplane enables stand-alone operation of an AMC FMC carrier or any other AMC board. It has 4 SFP connectors, 2 QSFP cages, 8 trigger I/O routed to the MLVDS ports and power entry. ...
  • uTCA RTM 8 SFP+
    The uTCA RTM 8 SFP is module equipped with 8 SFP cages and a clock distribution network. It is compatible with AFC and future projects such as Kintex-based AFC and WR MCH....

Also available in: Atom