Wrpc shell
pll |
|
|
|
init mode>
|
manually run spll_init() function to initialize SoftPll |
|
cl channel>
|
check if SoftPLL is locked for the channel |
|
sps channel>
|
set phase shift for the channel |
|
gps channel>
|
get current and target phase shift for the channel |
|
start channel>
|
start SoftPLL for the channel |
|
stop channel>
|
stop SoftPLL for the channel |
|
sdac index>
|
set the dac |
|
gdac index>
|
get dac's value |
gui |
|
|
|
|
starts GUI WRPC monitor |
stat |
|
|
|
|
prints one line log message |
|
cont |
prints log message for each second (Esc to exit back to shell) |
ptp |
|
|
|
start |
start WR PTP daemon |
|
stop |
stops WR PTP daemon |
mode |
|
|
|
|
prints available WR PTP modes |
|
grandmaster |
sets WRPC to operate as Grandmaster clock (requires external 10MHz and 1-PPS reference)(*) |
|
master |
sets WRPC to operate as Free-running Master(*) |
|
slave |
sets WRPC to operate as Slave node(*) |
measure_t24p |
|
|
|
|
starts calibration procedure that measures t2/4 phase transition |
time |
|
|
|
|
prints current time from WRPC |
|
raw |
prints current time in a raw format (seconds, nanoseconds) |
|
set sec>
|
sets WRPC time |
sfp |
|
|
|
detect |
prints the ID of currently used SFP transceiver |
|
erase |
cleans the SFP database stored in FMC EEPROM |
|
add ID>
|
stores calibration parameters for SFP to the database in FMC EEPROM |
|
show |
prints all SFP transceivers stored in database |
|
match |
tries to get calibration parameters from database for currently used SFP transceiver() |
init |
|
|
|
erase |
cleans initialization script in FMC EEPROM |
|
add cmd>
|
adds shell command at the end of initialization script |
|
show |
prints all commands from the script stored in EEPROM |
|
boot |
executes the script stored in FMC EEPROM (the same action is done automatically when WRPC starts after resetting LM32) |
mac |
|
|
|
get |
prints WRPC's MAC address |
|
getp |
re-generates MAC address from 1-wire digital thermometer or EEPROM |
|
set mac>
|
sets the MAC address of WRPC |
|
setp mac>
|
sets MAC address to the 1-wire EEPROM (if available) |
sdb |
|
|
|
|
prints devices connected to the Wishbone bus inside WRPC |
ip (*) |
|
|
|
get |
prints the IPv4 address of the WRPC |
|
set ip>
|
sets the IPv4 address of the WRPC |
* after executing _mode_ command, _ptp start_ is required to start WR PTP daemon in new mode
** requires running _sfp detect_ first
* available only with Etherbone support turned on