Some last-minute corrections (don't remember why/what)

4bcb9621 · Maciej Lipinski · 1d4db773 · 4bcb9621
Commit 4bcb9621 authored Jul 25, 2013 by Maciej Lipinski
Hide whitespace changes
Inline Side-by-side

Showing with 5 additions and 5 deletions

wrspec.tex documents/ISPCS2012-specialSession_submision/wrspec.tex +5 -5

No files found.
--- a/documents/ISPCS2012-specialSession_submision/wrspec.tex
+++ b/documents/ISPCS2012-specialSession_submision/wrspec.tex
@@ -150,14 +150,14 @@ ETHERNET\_SYNCE&2-6   & Ethernet $+$ Synchronous Ethernet, further specified in
 			  (i.e~SyncE without using Ethernet Synchronization Messaging Channel (ESMC) \cite{SynchE2}) \\ \hline
 4 or 5			& Syntonization distribution topology independent from PTP topology 
 			  (i.e.~SyncE using Ethernet Synchronization Messaging Channel (ESMC) \cite{SynchE2}) \\  \hline
-2 or 4			& Frequency loopback disabled \\ \hline
-3 or 5 	 		& Frequency loopback enabled			  \\ \hline
+2 or 4			& Recovered clock loopback disabled \\ \hline
+3 or 5 	 		& Recovered clock loopback enabled			  \\ \hline
 \end{tabular}
 \label{tab:transportSpecific}
 \end{table}

-When frequency loopback is enabled, a port (acting as a slave) which recovers frequency from the incoming data stream
-shall, after proper phase alignment, encodes such frequency into the outgoing data stream and send it back to the source
+When recovered clock loopback is enabled, a port (acting as a slave) which recovers frequency from the incoming data stream
+shall, after proper phase alignment, encode such frequency into the outgoing data stream and send it back to the source
 (a port acting as a master).


@@ -316,7 +316,7 @@ being in PTP\_UNCALIBRATED state. Consequently, the PTP\_SLAVE state shall be en

 The delay request-response mechanism shall be the only path delay measurement mechanism for this profile.
 It shall define default mapping using Annex F (networkProtocol=0003)
-with the transportSpecific flag set to 3 (i.e. SyncE without ECMS and with frequency loopback enabled).
+with the transportSpecific flag set to 3 (i.e. SyncE without ECMS and with recovered clock loopback enabled).
 However, using transportSpecific flag set to 0 (DEFAULT) is allowed if the link partner is not 
 SyncE-capable. Such a situation shall be detected and handled properly by a port implementing this profile, therefore guaranteeing 
 backward-compatibility and interoperability. \\