Files
Project Attachments
User Documentation
Talk at AIDA Kick-Off meeting, CERN, 16-18th February
AIDA Mini-TLU hardware as a Timepix TLU
Document discussing using the AIDA beam-telescope mini-TLU as a TLU for
the Timepix telescope.
See http://indico.cern.ch/conferenceDisplay.py?confId=130357 for other
documents
.
Block diagram of TLU firmware
AIDA TLU Note
Describes hardware interfaces and data format of AIDA/AIDA-2020 TLU
See
http://svn.ohwr.org/fmc-mtlu/trunk/documents/firmware/latex/AIDA_TLU_note.pdf
Technical Documentation
Circuit Schematic of mini-TLU version "C" for review.
Manufacturing information for LED+PMT power module
This PCB sits on top of main AIDA-2020 TLU PCB and provides indicator LEDs and +5V or +12V for PMTs.
Version "B" - first version had a bug in the position of bi-colour ( rather than tri-colour ) LED
Schematic for AIDA-2020 TLU (fmc_tlu_v1e)
Schematic for first production version of "full" TLU
( 4 * DUT connectors , 6 * trigger inputs )
Manufacturing data for LVDS on HDMI to TTL on Lemo
Connects to TLU HDMI connector and converts to/from TTL on Lemo-00
Direction of each signal selectable by DIP switch
Can be powered from TLU, or USB connector. Use a 0.1" inch jumper on J2 to select between USB powering or powering over the HDMI cable from the TLU.
N.B. DC-DC converters inside TLU can only cope with power drawn by one* converter board
Electrical wiring diagram for modules inside the TLU
Drawing showing how the mains ( 110V - 240V ) power is connected to AC-DC converter and then the 12V is distributed to fans and TLU PCBs.
Manufacturing data for passive adaptor HDMI <--> Lemo
Use for connecting AIDA-2020 TLU with HDMI connectors to DUTs that expect EUDET TLU RJ45 connection