added by Anders Wallin on 2018-11-24 11:56:56.698128
migrate to kicad5 symbols and footprints. only minor changes to
pcb-design. new PDF hardcopies of 2018.11 PCB, SCH, and BOM.
2018 September: Arduino MKR Zero controller and revised PCB
added by Anders Wallin on 2018-09-08 11:29:23.357138
Revised PCB with 10-pin IDC/ribbon-cable for powersupplies and
SPI-control. Control by Arduino MKR Zero with Ethernet shield. This
arduino will be easier to integrate into a 1U enclosure, and removing
the voltage-regulators for the mux-PCB simplifies the board.
2018 August: design revision
added by Anders Wallin on 2018-08-28 10:48:29.079865
Revised design 2018.08 with a single 10-pin IDC connector for 5V and
3.3V supplies and SPI-communications. Also working on Arduino MKR ZERO
2018 June: project created on ohwr
added by Anders Wallin on 2018-06-15 13:01:01.924587
Following two prototype PCBs and some testing the project has been
created on ohwr.org. Stay tuned for updates to the repository and
documentation during the next few weeks.