Release v3.2 (SCB)
Schematics:**
Connector_GTX.SchDoc:
- Added signals ARM_DEBUG_TXD, ARM_DEBUG_RXD (both from ARM) and USB_SWITCH_CTR (from FPGA)
- Powe_Supply.SchDoc:
- R37 changed from 4K7 to 10K
- C39 and C40 voltage rated increased up to 10V
I2C_Multiplexers.SchDoc:
- Added I2C Temperature Sensor TMP100 for sensing PCB Tª (placed close the PSU)
- FPGA_USB.SchDoc name changed by TEST_USB.SchDoc:
- Added two 1:2 multiplexer controlled by the FPGA. By default the usb port is connected to the ARM.
- USB CP2101 chip configuration changed to bus powered.
Connectors_GPIOs.SchDoc:
- Added individual PSU fan controlled by the signal FAN_BOX_EN_PB7.
- Added 0R resistors to choice the FPGA fan voltage (5V or 12V).
WR_LINK.SchDoc:
- Serial resistor on leds changed by 49R9 (FPGA fed) and by 133R (I2C fed)
PCB:**
- Power supply connector J7 orientation changed in order to allow connection of the new PSU.
- Added teardrops on vias.