Explore GitLab
Discover projects, groups and snippets. Share your projects with others
-
Projects / FMC High-Voltage supply - fmc-hv-2ch
FMC LPC card with two High Voltage (HV) outputs and one Low Voltage (5-10V) output. Has mV voltage sensing and mA current sensing capabilities. More info at the Wiki page
1updated -
Projects / FMC Motion Front-End
The FMC Motion Front-End (fmc-mfe) aims at providing analog and digital environment for the control of up to 8-axis. More info at the Wiki page
0updated -
Projects / AMC FMC Carrier Kintex Ultrascale AFCKU
AFCKU is dual FMC carrier in AMC format based on Kintex Ultrascale SoC devices. It supports White Rabbit and RTM modules. More info at the Wiki page.
0updated -
Projects / AMC FMC Carrier AFCZ
AFCZ is dual FMC carrier in AMC format based on ZU7EV or ZU11EG SoC devices. It supports White Rabbit and RTM modules. More info at the Wiki page.
0updated -
Projects / SIS1160 PCI-L IO add on
A front-end PCI board with LEMO connectors to interface with the GPIO interconnect pins of the SIS1160 FMC carrier. More info at the Wiki page
0updated -
Projects / FMC ADC 500M 14b 4cha
The FmcAdc500M14b4cha is a 4-channel 500 MSPS 14 bit ADC card in FMC (FPGA Mezzanine Card, VITA 57.1) format using a High Pin-Count (HPC) connector.
0updated -
Projects / samc-temp-thcpl-20ch
19"-rack mounted module which connects 20 single-ended K-type or N-type thermocouple channels with zQSFP+ to samb-temp-thcpl-fmc. Used in SAMbuCa project. More info at the Wiki page
0updated -
Projects / samb-temp-thcpl-fmc
FMC thermocouple card interfacing with zQSFP+ to samc-temp-thcpl-20ch which connects 20 single-ended K-type or N-type thermocouple channels. Used in SAMbuCa project. More info at the Wiki page
0updated -
Projects / fmc-temp-pt100-15ch
FMC HPC PT100 temperature sensor interface card. Allows connection of 15 sensors in a 4-wire configuration. Used in SAMbuCa project. More info at the Wiki page
0updated -
Projects / FMC FSI photodetection module 8ch
Frequency Scanning Interferometry (FSI) photodetection module with 8 channels. It enables data acquisition of optical signals from the gas cell, the reference interferometers and return signals of interferometer channels.
0updated -
Projects / DIOT Kintex Ultrascale-based Peripheral Board FMC Carrier
DI/OT Kintex Ultrascale-based Peripheral Board with HPC FMC and SODIMM DDR4 slot. More info at the Wiki page
1updated -
Projects / PXIe FMC Carrier Board - SPEXI7U
PXIe FMC carrier board for a HPC FMC card. Based on Xilinx Zynq UltraScale+. More info at the Wiki page
0updated -
0updated
-
Yi Liu / AIDA-2020 TLU - Gateware
FPGA Firmware ( "Gateware" ) for AIDA-2020 TLU and AIDA mini-TLU
Uses "IPBus Build" ( ipbb )
Build instructions at Instructions here
0updated -
Projects / FMC-PROFINET
FMC-PROFINET is a PROFINET device (“slave”) card based on the Siemens ERTEC200 chip in the FMC-LPC form-factor.
0updated -
Projects / Simple VME FMC Carrier 7 - SVEC7
A simple VME64x carrier for two high pin count FPGA Mezzanine Cards (VITA 57). It has memory and clocking resources and supports the White Rabbit timing and control network. Follow-up of SVEC.
0updated -
Milosz Malczak / adc-lib
This library provides a generic API for ADC devices, so that applications can use this API to access any of the supported ADC boards. Currently the library supports the following boards:
fmc-adc-100m14b14chaFor testing and debugging purpose it supports also a couple of virtual boards that you can use to start the development of your application.
0updated -
0updated
-
1updated