Skip to content

C
Conv TTL RS485 - Gateware
Commit 8c76fa81 authored by Theodor-Adrian Stana's avatar Theodor-Adrian Stana
Browse files
Options

doc: Small correctional change in gateware test procedure

parent fa122aae
Hide whitespace changes
Inline Side-by-side
Showing with 3 additions and 3 deletions
doc/gw-test-procedure/gw-test-procedure.tex
View file @ 8c76fa81
......@@ -193,7 +193,7 @@ on the external channel.
the DUT (Figure~\ref{fig:pulse-gen-cfg})
\item If the pulse generator is configurable, configure it as follows:
\begin{itemize}
\item 2~$\mu$s pulses
\item 1.2~$\mu$s pulses
\item approx. 5~V on 50~$\Omega$ load
\item 1 Hz frequency
\end{itemize}
......@@ -286,7 +286,7 @@ appears, check your gateware and restart the procedure.
\item \label{item:ttl-meas-ttl-out} Check that the characteristics of the signal
on \textbf{channel 1 of the oscilloscope} are as follows (Figure~\ref{fig:ttl-rs485}):
\begin{itemize}
\item 1.2~$\mu$s
\item approx. 1.2~$\mu$s
\item approx. 3~V
\end{itemize}
\item If the signal characteristics are as above, \textbf{tick} the \textbf{TTL column for the channel} on the \textbf{Front panel} side
......@@ -361,7 +361,7 @@ appears, check your gateware and restart the procedure.
\item \label{item:ttlbar-meas-ttl-out} Check that the characteristics of the signal
on \textbf{channel 1 of the oscilloscope} are as follows (Figure~\ref{fig:ttlbar-rs485}):
\begin{itemize}
\item 1.2~$\mu$s
\item approx. 1.2~$\mu$s
\item approx. 3~V
\end{itemize}
\item If the signal characteristics are as above, \textbf{tick} the \textbf{TTL column for the channel} on the \textbf{Front panel} side
......
Markdown is supported
0% or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment