Now you should execute the Makefile that should perform everything!
Now you should execute the Makefile that should perform everything!
...
@@ -832,7 +832,7 @@ wrc2# gui
...
@@ -832,7 +832,7 @@ wrc2# gui
~~~~~~~~~~
~~~~~~~~~~
~~~~~{.sh}
~~~~~{.sh}
WR PTP Core Sync Monitor wr-starting-kit-v3.0
WR PTP Core Sync Monitor wr-starting-kit-v3.1
Esc = exit
Esc = exit
TAI Time: Thu, Jan 1, 1970, 02:01:57
TAI Time: Thu, Jan 1, 1970, 02:01:57
...
@@ -864,7 +864,6 @@ Update counter: 7
...
@@ -864,7 +864,6 @@ Update counter: 7
You can see that the slave node is locked, calibrated and that the phase tracking is enabled.
You can see that the slave node is locked, calibrated and that the phase tracking is enabled.
> ***Notes:*** We also recommend you to set up an init script if you do not want to repeat these operations at each reboot. You can look at the [wrpc.pdf] for more information and use the `init show` command to check the one you have running.
> ***Notes:*** We also recommend you to set up an init script if you do not want to repeat these operations at each reboot. You can look at the [wrpc.pdf] for more information and use the `init show` command to check the one you have running.
...
@@ -1622,9 +1621,9 @@ gateware. However if you compare these PPS with the one of the switch
...
@@ -1622,9 +1621,9 @@ gateware. However if you compare these PPS with the one of the switch
and you do not obtain a delay similar as the one in the WRS figure above
and you do not obtain a delay similar as the one in the WRS figure above
you might need to calibrate the [WRS] and/or the [SPEC+FMCDIO].
you might need to calibrate the [WRS] and/or the [SPEC+FMCDIO].
The wr-starting-kit-v3.0 release has been calibrated for you for the SFPs
The wr-starting-kit-v3.1 release has been calibrated for you for the SFPs
provided to you. The values of the calibration parameters that you need to use
provided to you. The values of the calibration parameters that you need to use
with the wr-starting-kit-v3.0 can be found in the wiki page:
with the wr-starting-kit-v3.1 can be found in the wiki page: