This version is the one uploaded in ohwr.org at the moment of this commit.

It adds new features like --yes option, prints progress on the screen
and shows the state of the entire run.

tps/test: change thresholds in test00.py and ajust them taking in mind the possible errors in the resistors and reference voltage of the ADC

As the SPEC board use low count pin connector, the resistor divider
give us a value of 1.7 V in case of V_adj, when we read back from the
ADC present in the FMC tester.

In high pin count connector the threshold value is still 2.0 V.

"Semos cojonudos"

Conflicts:
	test/spec/python/test01.py

It is needed to change the header that indicates which version of python use.

Step by step... we walk the road.

It is still needed to clean up and change paths.

NOTE: it is needed to change paths and some minor work on the python files.
Signed-off-by: Samuel Iglesias Gonsalvez <samuel.iglesias.gonsalvez@cern.ch>

It is needed to change the header that indicates which version of python use.

Step by step... we walk the road.

It is still needed to clean up and change paths.

NOTE: it is needed to change paths and some minor work on the python files.
Signed-off-by: Samuel Iglesias Gonsalvez <samuel.iglesias.gonsalvez@cern.ch>

Some modifications have been done in order to give less path-dependency
to this script. This needs to be modified to make the modifications
completely transparent (check at the beginning, lines commented with
jdgc tag).

These were overlooked and should not remain there